Grill Daddy- TRANSFER (SS)

Temperature: 320°F to 330°F               
• Time: 15 seconds      
• Press the garment for 5 seconds to remove moisture and wrinkles.
• This ensures better adhesion of the transfer.
• Pressure: Medium to firm (about 60–80 PSI if your press measures)
Pre-Press the Garment
• Press the garment for 5 seconds to remove moisture and wrinkles.
• This ensures better adhesion of the transfer.

Position the Transfer
• Place the DTF transfer face-up on the garment (printed side down, film side up).
• Ensure correct alignment and positioning.

Heat Press the Transfer 
• Cover with Teflon or parchment paper (optional, but can help protect the film).
• Press at 320°F for 10–15 seconds with medium to firm pressure. 
• Do not peel the film yet!  

  ⸻    

• Allow it to cool on a flat surface for 30 to 60 seconds or until fully cold to the touch.
• This is essential for clean removal and strong adhesion.

⸻ 

 Peel the Film (Cold Peel)
• Once completely cool, peel the film off slowly and evenly from one corner.
• If any part lifts, repress for a few seconds and try again after cooling.

⸻  

 Second Press
• Cover the design with a Teflon sheet or parchment paper.
• Repress for 5–10 seconds to improve durability and give a softer, matte finish.